Ricoh SP C400DN User Manual page 65

Hide thumbs Also See for SP C400DN:

Table of Contents

Fully insert the 1284 interface board.

Confirm that the 1284 interface board is firmly connected to the controller

Tighten the two screws to secure the 1284 interface board.

❒ Use the supplied adaptor to make the connection with the computer.

❒ After finishing installation, you can check the 1284 interface board is prop-

erly installed: Print the configuration page from the [List/Test Print] menu.

If it is installed properly, "Parallel Interface" will appear for "Device Con-

nection" on the configuration page.

❒ If the 1284 interface board is not installed properly, reinstall it following

this procedure. If you cannot install it properly even after attempting rein-

stallation, contact your sales or service representative.

For printing the configuration page, see "Test Printing", Quick Installation

Attaching IEEE 1284 Interface Board Type A

Show Quick Links

Chapters

Table of Contents