Ricoh SP C400DN User Manual page 493

Message
Attach to print queue <print queue name>
Authentication mode mismatch< SSID >
centrod is disabled.
Cannot create service connection
Cannot find rprinter (<print server
name>/<printer number>)
Change IP address from DHCP Server.
child process exec error! (process name)
Client password rejected
Client tls certificate rejected
Connected DHCP Server(<DHCP serverad-
dress>).
Could not attach to FileServer<error number> (In the remote printer mode) Connection to the
Could not attach to PServer<print server>
Current Interface Speed: xxxMbps
Current IP address <currentIP address>
Current IPX address<IPX address>
DHCP lease time expired.
Problem and solutions
(In the print server mode) Attached to the
print queue.
Authentication mode is different to the AP.
The required SSID is the SSID of the access
point connected to when in infrastructure
mode.
Communication via parallel connectionis un-
available because centrod is disabled in the se-
curity mode.
Enable centrod in the security mode.
(In the remote printer mode) Connection to the
file server has not been established. The num-
ber of file server users may have exceeded the
maximum capacity of the file server.
The printer with the number displayed on the
print server does not exist. Make sure that the
printer number is registered on the print serv-
er.
The IP address changes when DHCP lease is
renewed. To always assign the same IP ad-
dress, set a static IP address to the DHCP serv-
er.
The network service failed to start. Turn the
printer off and then on. If this does not work,
contact your service or sales representative.
The client's password was rejected. Check the
client password.
The client's TLS certificate was rejected. Check
the certificate.
The IP address was successfully received from
the DHCP server.
file server has not been established. The file
server has refused the connection. Check the
file server configuration.
(In the remote printermode) Connection to the
print server has not been established. The
print server has refused the connection. Check
the print server configuration.
Speed of the network (10Mbps, 100 Mbps, or
1Gbps).
Current IPv4 address.
Current IPX address
DHCP lease time has expired.The printer tries
to discover the DHCP server again. The IP ad-
dress until now becomes invalid.
Message List
6
269