Ricoh SP C400DN User Manual page 473

Parameter
keyphrase " phrase" val {1|2|3|4}
encval {1|2|3|4}
wepauth [open|shared]
rate [auto|11m|5.5m|2m|1m]
security {none|wep|wpa}
wpaenc {tkip|ccmp}
wpaauth {wpapsk|wpa}
psk "character string"
Value configured
You can specify the WEP key when entering in
ASCII.
With a 64-bit WEP, you can use 10 digit hexadeci-
mals. With a 128-bit WEP, you can use 26 digit
hexadecimals.
Up to four WEP keys can be registered. Specify the
number to be registered with "val".
When a WEP is specified by key phrase, the WEP
specified by key is overwritten.
To use this function, set the same key number and
WEP key for all ports that transmit data to each other.
You can omit the numbers with "val". The key
number is set to 1 when making these omissions.
You can specify which of the four WEP keys is
used for packet encoding. "1" is set if a number is
not specified.
You can set an authorization mode when using
WEP. The specified value and authorized mode
are as follows:
open: open system authorized (default)
shared: shared key authorized rate
You can set the IEEE 802.11b transmitting speed.
The speed you specify here is the speed at which
data is sent. You can receive data at any speed.
auto: automatically set (default)
11m: 11 Mbps fixed
5.5m: 5.5 Mbps fixed
2m:2 Mbps fixed
1m: 1 Mbps fixed
You can specify the security mode.
none: No encryption(default)S
wep: WEP encryption
wpa: WPA encryption
You can specify WPA encryption key when using
WPA encryption.
tkip: TKIP (default)
ccmp: CCMP (AES)
You can specify the WPA authentication mode
when using WPA encryption.
wpapsk: WPA-PSK authentication(default)
wpa: WPA(802.1X) authentication
You can specify the Pre-Shared key.
Usable characters: ASCII 0x20-0x7e (8 to 63 bytes).
The default is blank.
Remote Maintenance by telnet
6
249