Ricoh SP C400DN User Manual page 180

Troubleshooting
❖ Alert Messages (in alphabetical order)
Address book data error.
Cannot print.
Connect failed:IEEE802.11b/Turn power off,
check card
Ethernet Board Error
Independent-supply toner
Parallel I/F Error
Printer Font Error.
9
The selected job has already been printed or
deleted.
USB has a problem
158
Messages Descriptions and recommended actions
This message appears when the previously in-
stalled hard disk drive is removed and rein-
stalled. To prevent this message appearing, do
not remove the hard disk drive. Contact your
local sales/service representative if this mes-
sage appears.
Check the file you want to print is a supported
file type. Check for misfeeds and ask your net-
work administrator for help.
Check there is an IEEE802.11b interface board
installed.
Check that it is a supported board. If it is,
check it is installed correctly.
Install the correct board properly.
For details, see p.42 "Attaching IEEE 1284 In-
terface Board Type A".
An error on the Ethernet board is detected. Re-
place the Controller Board.
Set toner cartridges specified by an authorized
dealer.
The printer's self diagnostic test failed due to a
loopback error. Replace the IEEE 1284 board
that caused the error.
For details, see p.42 "Attaching IEEE 1284 In-
terface Board Type A".
There are problems with the printer's font file.
Contact your sales/service representative.
This message might appear if you print or de-
lete a job from Web Image Monitor. Press [Exit]
on the message screen.
The printer cannot detect the USB host inter-
face board. It may be incorrectly installed.
Check if it is installed properly or contact your
sales/service representative.
For details about installing the unit, see p.44 "At-
taching the USB Host Interface Board Type A".