Ricoh SP C400DN User Manual page 186

Troubleshooting
Paper gets wrinkles.
Paper is not fed from the select-
ed tray.
A printed image is different
from the image on the comput-
er's display.
It takes too much time to turn on
the printer.
It takes too much time to resume
printing.
9
It takes too much time to com-
plete the print job.
164
Status
• Paper is damp. Use paper that has been stored properly.
• Paper is too thin.
• There may be a gap between the front guide and the pa-
• The fusing unit is deteriorated or damaged. Replace the
When you are using a Windows operating system, the print-
er driver settings override those set using the control panel.
Set the desired input tray using the printer driver.
See the printer driver Help.
• When you use some functions, such as enlargement and
• You might have selected to replace True Type fonts with
If the printer is turned off while it is still accessing the hard
disk (for example: during file deletion), the printer will re-
quire more time to power-up the next time it is turned on. To
avoid this time delay, do not turn the power off while it is in
operation.
• The data is so large or complex that it takes time to pro-
• If an OHP transparency or glossy paper is being used,
• The printer was in the Energy Saver mode. To resume
• Photographs and other data intensive pages take a long
• The data is so large or complex that it takes time to pro-
• If "Waiting..." appears on the display, the printer is now
Possible Causes, Descriptions, and Solutions
See p.77 "Paper and Other Media".
See p.77 "Paper and Other Media".
per, or between the side guides and the paper in the pa-
per tray. Make sure there are no gaps.
See p.89 "Loading Paper".
unit.
See p.132 "Replacing the Fusing Unit".
reduction, the layout of the image might be different from
that displayed in the computer display.
printer fonts in the printing process.
To print an image similar to the image on the computer,
make the settings to print out True Type fonts as an image.
See the printer driver Help.
cess it. If the Data In indicator is blinking, the data is be-
ing processed. Just wait until it resumes.
printing takes more time to start.
from the Energy Saver mode, the printer has to warm up,
and this takes time until printing starts. To disable the En-
ergy Saver mode, select [Off] for [Energy Saver] in the Sys-
tem menu.
time for the printer to process, so simply wait when print-
ing such data.
Changing the settings with printer driver may help to
speed up printing.
See the printer driver Help.
cess it. If the Data In indicator is blinking, the data is be-
ing processed. Just wait until it resumes.
warming up. Wait for a while.