Dial Tone; Tone Frequencies; Tone Timings; Busy Tone - Panasonic KX-HDV130 Administrator's Manual

4.6.5 Tone Settings

4.6.5.1 Dial Tone

Tone Frequencies

Description
Value Range
Default Value
Configuration File Reference

Tone Timings

Description
Value Range
Default Value
Configuration File Reference

4.6.5.2 Busy Tone

Tone Frequencies
Description
148 Administrator Guide
Specifies the dual-tone frequencies, in hertz, of dial tones using 2 whole
numbers separated by a comma.
0, 200–2000 (0: No tone)
Note
•
If the value for this setting is "350,440", the unit will use a mixed
signal of a 350 Hz tone and a 440 Hz tone.
425,0
DIAL_TONE1_FRQ (Page 282)
Specifies the pattern, in milliseconds, of dial tones using up to 10 whole
numbers (off 1, on 1, off 2, on 2...) separated by commas.
Note
•
The unit will not play the tone for the duration of the first value,
play it for the duration of the second value, stop it for the
duration of the third value, play it again for the duration of the
fourth value, and so on. The whole sequence will then repeat.
For example, if the value for this setting is "100,100,100,0", the
unit will not play the tone for 100 ms, play it for 100 ms, stop it
for 100 ms, and then play it continuously.
•
It is recommended that you set a value of 60 milliseconds or
more for the first value (off 1).
0–16000 (0: Infinite time)
Note
•
Avoid setting 1–50 for any of the values.
60,330,330,660,600
DIAL_TONE1_TIMING (Page 283)
Specifies the dual-tone frequencies, in hertz, of busy tones using 2
whole numbers separated by a comma.
Document Version 2015-12