Table of Contents
Advertisement
Install AT-IE210L-18GP Switch in Equipment Rack
These instructions show you how to install an AT-IE210L-18GP switch in
an equipment rack with parts from the AT-RKMT-J13 Rack Mount Kit. This
kit is not supplied with the switch, however, it can be purchased separately
from your Allied Telesis dealer.
Note
This following procedure assumes that the rubber feet are not
installed on the bottom of the chassis. If the rubber feet are installed,
complete the procedure in "Remove Rubber Feet From Switch
Chassis" on page 40 before installing the switch into the equipment
rack.
To install an AT-IE210L-10GP switch into a 19-inch equipment rack, follow
these steps using the brackets and screws supplied in the AT-RKMT-J13
Rack Mount Kit:
1. Attach two rack mount brackets to the sides of the switch using eight
bracket screws. Refer to Figure 14.
Figure 14. Attach Rack Mount Brackets to AT-IE210L-18GP Switch
IE210L Series Industrial Gigabit Ethernet Switch Installation Guide
43
Advertisement
Table of Contents
