Installing And Removing The Got; Installing The Got - Mitsubishi Electric GOT2000 Series User Manual

6.5

Installing and Removing the GOT

The following shows the procedure for installing and removing the GOT.
6.5.1

Installing the GOT

■1. GT27, GT25, GT23
Install the GOT in the following procedure.
For the panel cut dimensions for the GOT, refer to the following.
➠
6.2 Panel Cut Dimensions
The following shows an installation example for the horizontal direction.
For the vertical installation, install the GOT so that the vertical installation arrow printed on the GOT rear face points
upward.
➠ 4. PART NAMES AND SETTINGS
Step 1.
Insert the GOT rear face into the panel opening.
Step 2.
While positioning a fitting on the mounting hole of the GOT, tighten a screw within the specified torque range
(0.36 N·m to 0.48 N·m).
Tightening the screw with a torque exceeding the specified torque range may deform the GOT front panel,
causing the protective sheet to become crinkled.
GOT
For GT2715-X (8 fittings)
Panel opening

6.5 Installing and Removing the GOT

6
6 - 13