6.10 Installing and Removing the USB cable
The following shows the procedure for installing and removing a USB cable to the USB interface on the GOT rear face.
6.10.1
Installing the USB cable
Install the USB cable to the GOT in the following procedure.
Attach a cable clamp depending on the usage environment, such as when fixing a cable is difficult.
Step 1.
Install the USB cable to a USB interface (Host/device) on the GOT rear face.
Step 2.
Insert a cable clamp to the mounting hole for a cable clamp shown in the following figure and push it until
you hear a clicking sound. For the direction that the band goes through, refer to the arrow in the figure.
(Cable clamp used in this example: RSG-130-V0, KITAGAWA INDUSTRIES CO.,LTD.)
Step 3.
Pass the USB cable through a hole of the cable clamp and pull the band to fix the cable.
6.10 Installing and Removing the USB cable
6
6 - 37