6.9
Installing and Removing the USB Devices
The following shows the procedure for installing and removing a USB device.
6.9.1
Installing the USB devices
Step 1.
Push the [PUSH] mark on the USB environmental protection cover to open the cover.
Step 2.
Insert the USB interface to the USB interface (Host) as shown below.
Make sure to insert the USB interface connector in the correct direction.
6.9.2
Removing the USB devices
Step 1.
Place the USB device in removable mode.For the setting method, refer to the following.
➠
Step 2.
Remove the USB interface from the USB interface (Host) as shown below.
Step 3.
Push the [PUSH] mark on the USB environmental protection cover to close the cover.
6 - 36
6.9 Installing and Removing the USB Devices
POINT
POINT
POINT
The following shows the procedure for installing and removing a USB device
When connecting the devices to the USB interface (Host) using USB hub with the GOT power
on, drive assignment of connected USB devices may be changed.To use the USB hub devices,
turn on the GOT with the devices connected.
GOT2000 Series User's Manual (Utility)