Table of Contents
Advertisement
P-2
Installing the monitor
Using the wall mount or ceiling mount
Lay the screen face down
Lay the protective sheet on a table, which was wrapped around
the monitor when it was packaged, beneath the screen surface
so as not to scratch the screen surface.
Failure to follow the correct mounting procedures can result
in damage to the equipment or injury to the user or installer.
Product warranty does not cover damage caused by improper
installation.
Failure to follow these recommendations can void your
warranty.
For installation, use M6 iron screws (with a loose-proof spring
washer and having a length 10 mm longer than the thickness of
the mounting bracket) and tighten them securely. MITSUBISHI
ELECTRIC recommends using mounting interface that comply
with TÜV-GS and UL1678 standard in North America.
607.6
Handles
CAUTION:
For preventing the monitor from falling:
•
Install the monitor with metal brackets for wall or
ceiling installation (commercially available) on your own
responsibility. For detailed procedures of installation, refer
to the instructions of the metal brackets.
•
To avoid injury and damage resulting from fall of the monitor
in case of earthquake or other disaster, be sure to consult
the bracket manufacturer for installation location.
•
To avoid failing the monitor down, thread commercially
available rope through 4 handles of the monitor and secure
the rope to the wall mount brackets or ceiling mount
brackets. Use rope that can bear a load
6 times the weight of the monitor (approximately 222 kg).
•
Do not sleep where the monitor may topple over or fall in
case of an earthquake or other disaster.
•
Use screws having enough strength to support the LCD
display monitor (made of steel etc.).
Table
607.6
400
Protective Sheet
About the metal bracket:
•
Use a VESA-compliant metal bracket.
•
Before installation, make sure that the installation surface
has suffi cient strength.
•
Use a metal bracket (commercially available) that is strong
enough to hold the monitor.
•
Before installation, check the strength and other properties
to ensure the safety.
•
Do not block the heat dissipating holes in the monitor with
the metal bracket. See page 13.
•
For details of the mounting procedure and the safe
installation procedure, see the user instructions of the metal
bracket (commercially available) to be used.
•
Take measures such as using multiple metal brackets,
holding the monitor at several points, and taking measures
to prevent falling or dropping in case of a problem in the
metal bracket or the installation location.
Installing the wall mount bracket
When the wall mount brackets (option) are used, tiling in a
multi-screen confi guration can be adjusted more easily.
CAUTION:
Do not attempt to install the LCD monitor by yourself.
Consult your dealer for installation work.
Refer to User's Manual of the wall mount bracket (option) for
the detailed installation procedure.
(mm)
When the wall mount bracket (option) is installed, fi x the wire
using the clamper (accessory).
NOTE:
Fix the wire of the wall mount bracket (option) to the rear of the
LCD monitor using the clamper (accessory) to prevent the wire
from being caught.
English-14
Carry out as necessary
(option)
Wire
Clamper
Clamper
(accessory)
(accessory)
Advertisement
Table of Contents
