Installation Position - Mitsubishi Electric GOT2000 Series User Manual

6.3

Installation Position

To install the GOT, some distance is required between the GOT and the other devices.
■1. For GT27,GT25
Depending on the units and cables used for the GOT, the distance more than the described dimensions may be
required.
Install the GOT with consideration of the connector dimensions and the cable bend radius.
For the cable pull-out distance from the bottom of the GOT, refer to the following.
➠
For the vertical installation, install the GOT so that the vertical installation arrow printed on the GOT rear face points
upward.
➠
4.1 GT27, GT25
C
The following tables list the distance required between the GOT and the other devices.
The dimensions within the parentheses apply when no equipment generating radiated noise (such as a contactor) or
heat is installed near the GOT.
However, always keep the ambient temperature of the GOT to 55 °C or lower.
11.1 External Dimension Diagrams
B
A
Horizontal
D
C
Vertical
D
Panel thickness: 1.6 mm to 4 mm
A
Panel thickness: 1.6 mm to 4 mm
(0.06 to 0.16inch)

6.3 Installation Position

E
(0.06 to 0.16inch)
E
6
6 - 5