Starting Monitoring - Mitsubishi Electric GOT2000 Series User Manual

Step 4.
Turn on the GOT.
To start the GOT with the built-in flash memory (Drive C), write the package data to the built-in flash
memory (Drive C) of the GOT.
For how to write the package data, refer to the following.
➠
To start the GOT with the data storage (Drive A, B, D to G), writing the package data to the built-in flash
memory (Drive C) of the GOT is not required.
■5. Connecting the GOT and the controller
Step 1.
Check the communication settings in the utility screen of the GOT.
➠
Step 2.
Turn off the power of the GOT.
Step 3.
Connect the GOT and controller with a cable.
➠
■6. Starting monitoring
Step 1.
Turn on the GOT and the connected system.
Step 2.
The GOT starts monitoring.
8 - 4
8.1 Outline Procedure to Start the GOT
GOT2000 Series User's Manual (Utility)
GOT2000 Series User's Manual (Utility)
GOT2000 Series Connection Manual For GT Works3 Version1 compatible for a controller used
POINT POINT POINT
Precautions when the startup source of the GOT is any other than the built-in flash
memory (Drive C)
(1) GOT startup time
The GOT startup time is longer than the normal startup time.
The GOT startup time differs depending on the data storage type, number of written
applications, and package data size.
(2) Handling the SD card during the GOT startup
When the startup source is the SD card (Drive A), do not open the cover of the SD card
interface during the GOT startup.
Doing so causes the GOT to fail to start normally.
(3) Corrective actions when the GOT cannot be started
The GOT cannot be started in any of the following conditions.
Take the following corrective actions, and turn on the GOT again.
Condition
The type of the physical GOT differs from the
GOT type of the package data stored in the SD
card.
The GOT has insufficient memory.
Corrective action
Prepare the SD card that stores the package
data containing the GOT type same as the GOT
to be used.
Delete unnecessary data in the memory of the
GOT.
➠
GT Designer3 (GOT2000) Help