Installing The Monitor; Installing And Removing The Stands; Using The Wall Mount Or Ceiling Mount - Mitsubishi Electric MDT55IS User Manual

P-2

Installing the monitor

Installing and removing the stands

The stands are available as option.
Refer to the user's manual of the stand for more information.
How to install the stands
1. Turn the monitor off.
2. Remove the screws that are securing the option stand
covers on both sides, and then remove the stand covers
from the monitor.
Stand cover x 2
3. Insert the option stands in the guide frames on both sides
to the end.
Secure the option stands on both sides fi rmly using the
screws supplied with the option stands.
Screw x 4
(Accessories of
the option stand)
Option stand x 2
(Longer portion comes to the front.)
4. Install the monitor on a fl at and stable surface.
NOTE:
• Install the stands so that their longer portions come to the
front.
• Retain the stand covers and screws you removed because
they are necessary when you install the monitor without the
option stands.
How to remove the stands
1. Spread the protective sheet on a fl at surface, such as a
desk.
2. Place the monitor on the protective sheet.
3. Remove the screws to remove the option stands.
4. Fasten the stand covers on both sides using the screws.
Screw x 2

Using the wall mount or ceiling mount

Lay the screen face down
Lay the protective sheet on a table, which was wrapped around
the monitor when it was packaged, beneath the screen surface
so as not to scratch the screen surface.
This device cannot be used or installed without the Tabletop
Stand or other mounting accessory. Failure to follow the correct
mounting procedures can result in damage to the equipment or
injury to the user or installer. Product warranty does not cover
damage caused by improper installation.
Failure to follow these recommendations can void your
warranty.
Use M8 screws (having a length 15 mm longer than the
thickness of the mounting bracket) and tighten them securely.
Prevent the screws from loosening using spring washers, etc.
MITSUBISHI ELECTRIC recommends using mounting interface
that comply with TÜV-GS and UL1678 standard in North
America.
625.5
Table
CAUTION:
For preventing the monitor from falling.
• Install the monitor with metal brackets for wall or
ceiling installation (commercially available) on your own
responsibility. For detailed procedures of installation, refer
to the instructions of the metal brackets.
• To lessen the probability of injury and damage resulting
from fall of the monitor in case of earthquake or other
disaster, be sure to consult the bracket manufacturer for
installation location.
• To lessen the risk of falling of the monitor, thread
commercially available rope through the handles at the
right and left of the monitor and secure the rope to the wall
mount brackets or ceiling mount brackets.
• Do not sleep where the monitor may topple over or fall in
case of an earthquake or other disaster.
• Use screws having enough strength to support the LCD
display monitor (made of stainless steel etc.).
English-14
Carry out as necessary
625.5
Handles
200 200
Protective Sheet
(mm)