Outline Procedure To Start The Got - Mitsubishi Electric GOT2000 Series User Manual

8.1

Outline Procedure to Start the GOT

This section explains the outline procedure to operate the GOT.
■1. Preparing project data
Step 1.
Install GT Designer3 Version1 on the personal computer.
For how to install GT Designer3 Version1, refer to the following.
➠
Step 2.
Create project data with GT Designer3 Version1.
For how to use GT Designer3 Version1 and create project data, refer to the following.
➠
■2. Installing an extension unit and option
Step 1.
Install options other than the SD card and USB memory to the GOT.
For how to install options, refer to the following.
➠
➠
Step 2.
Install an extension unit to the GOT.
For how to install extension units, refer to the following.
➠
■3. Installing the GOT, and power supply wiring
Step 1.
Install the GOT to the control panel.
For how to install the GOT, refer to the following.
➠
Step 2.
Carry out wiring of power cables for the GOT.
For the wiring of power cables, refer to the following.
➠
8 - 2
8.1 Outline Procedure to Start the GOT
Installing an extension unit and option
Installing the GOT, and power supply wiring
Connecting the GOT and the controller
GT Works3 Version1 Installation Instructions
GT Designer3 (GOT2000) Help
6.7 Installing and Removing the Battery
User's Manual of each option
6.6 Installing and Removing the Extension Unit
6.5 Installing and Removing the GOT
7. WIRNG OF POWER SUPPLY SECTION
Start
Preparing project data
Writing package data
Starting monitoring
End