Removing The Rear Wheel - Husqvarna CR 125 2011 Workshop Manual

1
Workshop Manual Ed. 06-2011
CHASSIS AND WHEELS
CR 125 2011 - WR 125 2011
H06867

Removing the rear wheel

Set a stand or a block under the engine and see that the rear wheel is lifted
from the ground.
Unscrew the nut (1) of the wheel axle (3) and extract it. It is not necessary
to loosen the chain tensioners (2); in this way, the chain tension will remain
unchanged after reassembly. Extract the complete rear wheel, keeping the
spacers located at the hub sides. To reassemble, reverse the above procedure
2
remembering to insert the brake disc into the calliper.
H06872
Do not operate the rear brake pedal when the wheel has been
removed; this causes the calliper pistons to move outwards.
After removal, lay down the wheel with brake disc on top.
After reassembly, depress the brake pedal until the pads are against
the brake disc.
Tightening torque figures
1= 142.1 Nm, 14.5 Kgm, 104.8 ft/lb
Y.10