Pin-Flywheel-Connecting Rod Big End Clearance - Husqvarna CR 125 2011 Workshop Manual

D
"E" connecting rod small end hole diameter colour selection - mm
(in.)
White
30.014÷30.016 (1.1816÷1.1817)
Black
30.016÷30.018 (1.1817÷1.1818)
Black
30.016÷30.018 (1.1817÷1.1818)
Red
30.018÷30.020 (1.1818÷1.1819)
Workshop Manual Ed. 06-2011
ENGINE OVERHAUL
CR 125 2011 - WR 125 2011

Pin-flywheel-connecting rod big end clearance

The table below is a list of the possible clearances allowing to reach the right
radial clearance of 0.20÷0.028 mm. If, during engine overhaul, a radial clear-
ance higher than the max. allowed value of 0.050 is found, it will not be neces-
sary to measure the diameter "E" of connecting rod big end and the diameter
"D" of flywheel pin. Based on these values, assemble the suitable needle roller
bearing cage.
3
NOTE: When asking for the needle roller bearing cage, specify
the selection.
H06572
E
3
H06573
"D" pin-flywheel-connecting rod big end hole diameter colour
selection - mm (in.)
Black
23.998÷23.996 (0.9448÷0.9447)
White
23.996÷23.994 (0.9447÷0.9446)
Red
24.000 ÷23.998 (0.9449÷0.09448)
Black
23.998÷23.996 (0.9448÷0.9447)
G.10
Needle roller bearing cage diameter selec-
tion
-2÷-4
0÷-2
-2÷-4
0÷-2