Digital Dashboard, Warning Lights (Wr) - Husqvarna CR 125 2011 Workshop Manual

CR 125 2011 - WR 125 2011
1
2
ELECTRICAL SYSTEM

DIGITAL DASHBOARD, WARNING LIGHTS (WR)

The motorcycle is equipped with a digital instrument; on the instrument are
located 2 warning lights too: high beam and blinkers.
1- BLUE warning light "HIGH BEAM"
2- GREEN warning light "BLINKERS"
The instrument display illuminates (amber colour) when the engine started.
NOTES:
A
- Every time the engine starts, for the first 2 seconds, the instrument shows
the version of the checking SW; after the check, the instrument shows the
last planned function.
H06977
- When the motorcycle engine is OFF, the instrument doesn't also show its
functions.
- To select the instrument functions and to set to zero the functions, use the
SCROLL knob (A).
The instrument functions are the following, as shown below:
1- SPEED / ODO (figure 1)
2- SPEED / CLOCK (figure 2)
3- SPEED / TRIP (figure 3)
4- SPEED / CHRONO (figure 4)
1- SPEED / ODO (figure 1)
.................
H06978
1- SPEED (Km/h or mph) / ODO (figure 1)
- SPEED: motorcycle speed- maximum value: 299 Km/h or 299 mph;
A
- ODO: odometer- maximum value: 99999 km.
To replace kilometers with miles or miles with kilometers proceed as follows:
1) set to figure 1, stop the engine and push the knob SCROLL (A);
2) start the engine holding pushed the button SCROLL (A) until the symbol
"Km/h" will be displayed;
3) then the symbols "Km/h" and "Mph Miles" will be displayed alternatively.
Push again the SCROLL (A) button when the unit you wish to use is dis-
played.
H06979
M.27
Workshop Manual Ed. 06-2011