Alternator Inspection; Electronic Ignition System (Cr) - Husqvarna CR 125 2011 Workshop Manual

Workshop Manual Ed. 06-2011
ELECTRICAL SYSTEM
CR 125 2011 - WR 125 2011

Alternator inspection

Disconnect the three yellow cables coming from the alternator from the regulator,
taking care to properly insulate them so as not to let them contact each other.
Take engine to approx. 3,000 rpm, and measure the open-circuit voltage using
an alternate current voltmeter with a scale up to at least 50V.
Tester will show a certain voltage value (>20V <50V).
If no value is shown or in case a great voltage unbalance is present across yel-
low cables, then stator is faulty. It will thus be necessary make a further check
using an Ohmmeter, measuring the insulation between the tested cable and
ground. This insulation shall be total, i.e. with infinite resistance.
H02541

Electronic ignition system (CR)

The electronic ignition system includes the following elements:
1) 12V generator - 500W
2) Electronic control unit
3) Stop switch
4) Electronic coil
5) Spark plug
M.10
3
4
5
2
1
H06964