Husqvarna CR 125 2011 Workshop Manual page 158

6
4
5
Workshop Manual Ed. 06-2011
FRONT SUSPENSION
CR 125 2011 - WR 125 2011
Mount sealing rings and metal parts on the inner tube.
See the figure below for the installation sequence.
Grease the edge of the sealing ring.
Before sliding the sealing ring over the inner tube, cover tube edge
with plastic as shown in the figure.
This will avoid damage to the oil seal lip.
7
8
9
H06836
Fit metal bushing and washer to outer tube using an appropriate installer.
Fit the oil seal to the outer tube and push it home using an appropriate in-
staller.
Make sure that the retaining ring groove inside the outer tube is fully visible.
H06837
Install the retaining ring.
Make sure that the retaining ring is fully seated in the groove inside the outer
tube.
H06838
I.10