Servicing Right-Side Components - Arctic Cat 2014 450 Service Manual

13. Remove the cam chain.
14. Remove the oil pump drive gear cap screw.
15. Remove the snap ring holding the oil pump driven
gear.
 NOTE: Always use a new snap ring when installing
the oil pump driven gear.
16. Remove oil pump driven gear. Account for the drive
pin and thrust washer.
MD1016

To service clutch components, see Servicing Right-Side
Components sub-section.
17. Remove three screws holding the oil pump and
remove the oil pump. Account for two alignment
pins.
MD1335

To service center crankcase components only, proceed
to Separating Crankcase Halves.
MD1018
Servicing Right-Side
Components
INSPECTING CENTRIFUGAL
CLUTCH SHOE
1. Inspect the clutch shoe for uneven wear, chips,
cracks, or discoloration.
2. Inspect the depth of the grooves in the clutch shoes.
If any shoe is worn to the bottom of the groove,
replace the complete set.
Always replace clutch shoes as a complete set or
MD1019
severe imbalance could occur.
AT THIS POINT
AT THIS POINT
CAUTION
MD1020
MD1060
61