Arctic Cat 2014 450 Service Manual page 58

3. Inspect the one-way bearing for chipped surfaces,
missing rollers, or discoloration. If any of the above
conditions exist, replace the starter clutch assembly.
REPLACING STARTER CLUTCH
ASSEMBLY
1. Remove the cap screws securing the one-way clutch
assembly to the flywheel; then remove from the fly-
wheel.
2. Thoroughly clean the rotor/flywheel; then install the
new one-way clutch and secure with the cap screws
after applying a drop of red Loctite #271 to the
threads. Tighten to 26 ft-lb using a crisscross pattern.
Make sure the one-way bearing is installed with the
notches directed away from the rotor/flywheel.
REPLACING STARTER GEAR
BEARING
FI572
1. Support the starter clutch gear in a press making sure
to support the hub around the entire circumference;
then using a suitable bearing driver, press the bearing
from the gear.
2. Thoroughly clean the gear hub; then apply a drop of
green Loctite #620 to the bearing outer race and
FI570
press into the gear hub until even with the lower
chamfer radius.
INSPECTING STATOR/MAGNETO
COVER ASSEMBLY
1. Inspect the stator for burned or discolored wiring,
FI576A
broken or missing hold-down clips, or loose cap
screws.
2. Inspect the bearings in the magneto housing for dis-
coloration, roughness when rotated, and secure fit in
bearing bores.
FI578
FI583
FI580
55