Arctic Cat 2014 450 Service Manual page 18

3. Remove the headlight bulb assembly from the head-
light housing.
4. Install the new headlight bulb into the headlight
housing being careful not to get fingerprints or other
contaminates on the glass; then secure with the
spring.
5. Connect the wiring harness connector to the bulb;
then install the protective rubber boot making sure it
seals completely on the headlight harness.
TAILLIGHTS-BRAKELIGHTS
To replace a taillight-brakelight bulb, use the following
procedure.
1. Turn the bulb socket assembly counterclockwise and
remove from the housing.
KC163A
2. Press in and turn the bulb counterclockwise to
remove. Press in and turn clockwise to install the
bulb.
3. Insert the bulb socket assembly into the housing and
turn it clockwise to secure.
RUNNING LIGHTS/BACK-UP LIGHTS
The running lights are located outboard of the headlights,
and the back-up lights are outboard of the tail-
lights/brakelights. To replace the bulbs, use the following
procedure.
1. Rotate the bulb socket counterclockwise to release
from light housing; then press in on the bulb and turn
counterclockwise to release from the socket.
KC163B
2. Install a new bulb and press in rotating clockwise to
secure; then place the socket into the light housing
and turn clockwise to secure.
KC146
KC157
KC158A
KC158B
15