Table of Contents
Advertisement
3. Inspect the oil pressure relief valve for evidence of
metal chips or contamination. Do not disassemble
the valve.
REPLACING STATOR/CRANKSHAFT
POSITION SENSOR
1. Remove the three cap screws securing the stator coil,
two cap screws securing the crankshaft position sen-
sor, and one cap screw from the harness hold-down.
2. Lift the rubber grommet out of the housing; then
remove the stator coil/crankshaft position sensor.
Account for and note the position of the harness
hold-down under the crankshaft position sensor.
3. Install the new stator assembly and secure with three
cap screws using a drop of red Loctite #271 on each.
Tighten to 8 ft-lb.
4. Place the stator wire harness hold-down into posi-
tion; then install the crankshaft position sensor and
secure with two cap screws. Tighten securely.
5. Install the upper cable hold-down and secure with a
cap screw. Tighten securely.
56
REPLACING MAGNETO COVER
BEARINGS
FI588
1. Using a suitable press and proper support, press the
bearing from the housing as indicated (one from out-
side and one from inside).
FI590
2. Clean the bearing bores in the housing and inspect
closely for cracks or shiny areas indicating bearing
movement. Replace the housing if any of the above
are evident.
3. With a drop of red Loctite #271 around the bearing
bore, press a new bearing into the magneto cover
until the bearing is firmly seated in the bearing bore.
FI595A
FI593
FI594
Advertisement
Table of Contents
Troubleshooting
