Lcd Gauge; Handlebar Grip - Arctic Cat 2014 450 Service Manual

3. Using red Loctite #271 on the threads, install the tie
rod ends into the lower steering post arm and tighten
to 30 ft-lb; then install new cotter pins.
4. Place the handlebar and caps in place on the steering
post and with the handlebar correctly positioned,
tighten the cap screws to 20 ft-lb.
5. Install the steering post cover; then install the front
body panel/fender.

LCD Gauge

REPLACING
1. Remove two machine screws securing the gauge pod
to the mounting bracket; then lift the pod off and dis-
connect the wiring connector and remove the mount-
ing nuts and gauge.
26
KC307A
2. Install the new gauge and secure with the mounting
screws; then connect the gauge to the main harness
and install the gauge pod. Tighten the machine
screws securely.

Handlebar Grip

REMOVING
1. Loosen but do not remove the cap screw in the end of
the handlebar; then tap lightly on the head to dis-
lodge the handlebar plug.
KC184A
KC0058
2. Grasp the end and remove the cap screw, plug, and
end cap.
KC353D
KC310
KC309A