Table of Contents
Advertisement
6. Remove the snap ring securing the input shaft bear-
ing; then place the pinion housing in a press and
remove the bearing.
108
Assembling Input Shaft
1. Place the pinion housing in a press and install the
input shaft bearing. Secure the bearing with the
existing snap ring making sure the sharp edge of the
snap ring faces to the outside.
AF982
AF983
2. Install the input shaft seal making sure it is flush with
the edge of the housing.
3. Lubricate the input shaft splines with High-Perfor-
mance #2 Molybdenum Disulphide Grease.
NOTE: Any time drive splines are separated, clean
all splines with parts-cleaning solvent and dry with
compressed air; then lubricate with recommended
grease.
AF984
KX219
AF993
AF994
KX221
Advertisement
Table of Contents
Troubleshooting
