Table of Contents
Advertisement
8. Tighten the clutch cover cap screws to 8 ft-lb.
9. Install the air intake plate. Apply red Loctite #271 to
the threads of the three Phillips-head cap screws;
then install and tighten securely.
10. Place the driven pulley assembly into position and
secure with the nut (threads coated with red Loctite
#271). Tighten to 147 ft-lb.
64
MD1115
11. Slide the fixed drive face assembly onto the front
MD1117
shaft.
12. Spread the faces of the driven pulley by threading a
V-belt cover cap screw into the fixed driven face and
tightening until the faces open sufficiently to allow
the V-belt to drop into the pulley approximately 3/4
in.
MD1342
NOTE: The arrows on the V-belt should point in
direction of engine rotation.
13. Making sure the movable drive face rollers are in
position, pinch the V-belt together near its center and
slide the spacer and movable drive face onto the
shaft.
MD1068
KC134
KC137
Advertisement
Table of Contents
Troubleshooting
