Right-Side Components; Removing Right-Side Components - Arctic Cat 2014 450 Service Manual

10. Install the water pump drive gear and secure with the
nut. Tighten to 28 ft-lb.
11. Install two alignment pins and a gasket on the mag-
neto cover; then install the water pump housing
assembly. Tighten the cap screws to 8 ft-lb.
58
12. Install the water pump cover with a new O-ring and
secure with the four cap screws. Tighten to 8 ft-lb.
FI596A
13. Connect the coolant hoses to the water pump and
secure with the hose clamps. Tighten securely.

Right-Side Components


To service center crankcase components only, proceed
to Removing Right-Side Components.
 NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to
FI547
be addressed and to service only those components.
The technician should use discretion and sound
judgment.

To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.
 NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
Removing Right-Side
Components
FI541A
A. V-Belt Cover
B. Driven Pulley
C. Clutch Cover
1. If the engine is still in the frame, remove the cap
screw securing the brake pedal to the pivot shaft.
Account for a flat washer.
FI539
AT THIS POINT
AT THIS POINT
FI538