Table of Contents
Advertisement
NOTE: Always use a new snap ring when installing
the oil pump driven gear.
3. Install the cam chain.
NOTE: Keep tension on the cam chain to avoid dam-
aging the crankcase boss.
4. Place the pin into position, install the oil pump drive
gear, and tighten the cap screw (coated with red Loc-
tite #271) to 63 ft-lb.
5. Install the clutch shoe assembly on the crankshaft;
then install the flange nut (left-hand thread) (coated
with red Loctite #271). Tighten to 147 ft-lb.
MD1020
NOTE: The flat side of the flange nut should be
directed towards the clutch shoe.
Care must be taken when installing the flange nut; it has
"left-hand" threads.
6. Install the one-way clutch making sure that the green
dot or the word OUTSIDE is directed away from the
crankcase.
MD1019
B. Clutch Cover
C. Fixed Drive Face
D. Movable Drive Face
NOTE: Steps 1-6 in the preceding sub-section must
precede this procedure.
7. Install two alignment pins and place the clutch cover
gasket into position. Install the clutch cover.
MD1017
CAUTION
MD1018
MD1286
63
Advertisement
Table of Contents
Troubleshooting
