Joining Crankcase Halves - Arctic Cat 2014 450 Service Manual

9. Install the input driveshaft.
10. Install the spacer (1), shaft (2), reverse idler gear, and
washer (3).
74
11. Install the secondary output driveshaft assembly into
the crankcase half making sure the front and rear
bearing alignment pins are seated in the recesses;
then install the center carrier bearing alignment
C-ring.
FI655A
FI646
FI641A

Joining Crankcase Halves

1. Verify that the two alignment pins (A) are in place
and that both case halves are clean and grease free.
Apply Three Bond Sealant to the mating surfaces.
Place the right-side half onto the left-side half.
FI645
FI660A
FI659A
FI661A