Arctic Cat 2014 450 Service Manual page 118

2. Using a press, remove the bearing.
3. Using a press, install the new bearing into the hous-
ing.
 NOTE: Prior to installing the seal, apply High Perfor-
mance #2 Molybdenum Disulphide Grease to the seal
outside diameter.
4. Using an appropriate seal installation tool, evenly
press the seal into the cover bore until seated.
CAUTION
Make sure the tool is free of nicks or sharp edges or the
seal will be damaged.
GC066
5. Repeat steps 1-4 for the opposite side.
INSTALLING DIFFERENTIAL
1. Align the input flange with the front output flange;
then place the differential into position on the frame
and install the cap screws and nuts. Tighten to 38
ft-lb.
CC900
2. Install the cap screws securing the flange couplers
together and tighten to 20 ft-lb.
CC901
3. Install the front axles.
GC060
KC291A
AG925
115