Table of Contents
Advertisement
3.7 Virtual Doorman
The virtual doorman is an independent system that provides communication from the lobby area to a
company that provides doorman services. The virtual doorman service is completely separate from the
1816 system and does not utilize the 1816 lobby panel or any communication circuits provided by the
1816 system.
When virtual doorman service is active and a call is initiated from the 1816 lobby panel, the 1816 will
provide a dry relay contact to the virtual doorman system to activate the virtual doorman system. At
the same time, the 1816 will disconnect the lobby panel and hang up. The virtual doorman equipment
will provide all communication and door access for visitors.
3.7.1 Virtual Doorman On / Off – System Wide
This programming sequence is used by the doorman or system administrator to turn the virtual doorman
function On or Off and sets the 1885 on board relay to function as a virtual doorman relay or a door
strike relay.
Factory Default = 0 (Off)
1. Take the doorman telephone off hook.
2. Press *52 and enter the four-digit MASTER CODE _ _ _ _ (beep).
3. Enter 0 to turn virtual doorman Off, or enter 1 to turn virtual doorman On, then press *
(beep).
4. Hang up the doorman telephone to end the programming session.
3.7.2 Set Virtual Doorman Relay Strike Time
This programming sequence is used by the doorman or system administrator to set the strike time for
the virtual doorman activation relay. Strike time can be set from 1 to 99 seconds.
Factory Default = 01
1. Take the doorman telephone off hook.
2. Press *53 and enter the four-digit MASTER CODE _ _ _ _ (beep).
3. Enter a two-digit strike time (01-99) _ _ then press * (beep).
4. Hang up the doorman telephone to end the programming session.
3.7.3 Virtual Doorman On / Off per Resident
This programming sequence is used by the doorman or system administrator to turn virtual doorman
On or Off for each resident or for all residents. Entering 9 9 9 9 in this step will turn this feature on or
off for ALL residents.
Note: If programmable directory codes are used, enter the directory code number instead of
the relay number in step 3.
Factory Default = 0 (Off)
1. Take the doorman telephone off hook.
2. Press *43 and enter the four-digit MASTER CODE _ _ _ _ (beep).
3. Enter the four-digit relay number of the resident that virtual doorman is being administered
for _ _ _ _ then press * (beep).
4. Enter 0 to turn virtual doorman Off, or enter 1 to turn virtual doorman On then press *
(beep).
5. Repeat steps 3 and 4 to administer virtual doorman for other residents.
6. Hang up the doorman telephone to end the programming session.
1816-065-L-11-14
Page 39
Advertisement
Table of Contents
