4.2.2 Reset Main Control Board Resident Programming
This programming sequence will reset the programming specific to each resident to the 1885 main
control board to the factory default values. This function will take about 5 seconds to complete. The
power LED on the main control board will flash during the process.
NOTE: This command will perform command function 91 (4.2.1) automatically.
1. Take the doorman telephone off hook.
2. Press *90 and enter the four-digit MASTER CODE _ _ _ _ (beep).
3. Enter 9 9 9 9 then press * (beep).
4. Hang up the doorman telephone to end the programming session.
Function
Section
18
3.2.3
15
3.2.4
11
3.3.3
00
3.4.3
21
3.5.2
22
3.5.3
23
3.5.4
39
3.6.2
49
3.6.4
48
3.6.7
43
3.7.3
Page 44
Defa ult
Description
Turns off d o orm a n / lob b y c a ll op tion
Delete a ll d irec tory c od e p rog ra m m ing
Delete a ll p rep rog ra m m ed p hone num b ers
Delete a ll entry c o d es
0
Do not d isturb tim er O FF
0
Sc hed uled d o no t d isturb OFF
Sc hed uled d o no t d isturb set to 12:00 AM -- - 06:00
AM Sund a y - Sa turd a y
0
Ca ll forw a rd OFF
Delete a ll c a ll forw a rd ing num b ers
Delete a ll a rea c od e p ro g ra m m ing
0
Virtua l d oorm a n OFF
1816-065-L-11-14