Continuous - JAI GO-5000M-USB User Manual

Exposure Active
Frame Active
CCD Readout
Stream Active
Acquisition Status
◆ Forcing acquisition to stop
While AcquisitionActive is "TRUE", if AcquisitionStop or AcquisitionAbort is
initiated, AcquisitionActive becomes "FALSE" (stop capturing).
Once the operation is set to "FALSE", the internal FrameCount is reset.
However, if AcqusitionStop command is initiated during image output period,
AcqusitionActive becomes "FALSE" (stop capturing) after image output is completed.
Once, AcqusitionActive becomes "FALSE", the internal count is reset.
Associated commands: Acqusition Start, Acqusition Frame Count, Acquisition Stop
8.1.1.3

Continuous

In this mode, when the AcquisitionStart command is set, the image is continuously output at the
current frame rate. This is the default setting for the GO-5000M-USB and GO-5000C-USB.
1) AcquisitionStart command is input
2) AcquisitionTriggerWait becomes effective
3) AcquisitionActive becomes "TRUE"
4) Images begin outputting continuously
5) AcquisitionStop command is sent
6) AcquisitionActive becomes "FALSE". At this moment, the output stops.
However, if AcqusitionStop command is initiated during image output period,
AcqusitionActive becomes "FALSE" (stop capturing) after image output is completed.
GO-5000M-USB / GO-5000C-USB
In case that AcquisitionFrameCount is N
Frame 1
Acquisition Start
Acquisition
Trigger
Wait
Setting range of AcquisitionFrameCount is; 1≦ AcquisitionFrameCount ≦ 255(0xFF)
Acquisition
Active
- 34 -
Frame N
Acquisition
Trigger Wait