Trigger Selector; Trigger Mode; Trigger Source; Trigger Activation - JAI GO-5000M-USB User Manual

8.3.1

Trigger Selector

Selects the trigger operation. In the GO-5000-USB, the following trigger operation can be
selected as the trigger.
Table – 19
Trigger Selector Item
Acquisition Start
Acquisition End
Frame Start
Acquisition Transfer Start
Each trigger selection has its own settings. Therefore, it is necessary to set up the following items
on each selected trigger.

Trigger Mode

Trigger Source

Trigger Activation

8.3.2 Trigger Mode
Select either free-running operation or external trigger operation.
OFF:
ON:
8.3.3 Trigger Source
The following signals can be used as the trigger source signal.
Table – 20 Trigger source
Trigger Source
Description
item
Connect LOW level signal to the selected trigger operation
Low
Default setting
High Connect HIGH level signal to the selected trigger operation
Connect Soft Trigger signal to the selected trigger operation
Soft Trigger Trigger can be input manually by the execution of the software trigger
Trigger software is available on each trigger source.
PulseGenerator0
Connect Pulse Generator 0 signal to the selected trigger operation
Out
User Output 0 Connect User Output 0 signal to the selected trigger operation
User Output 1 Connect User Output 1 signal to the selected trigger operation
Line 5 - OPT IN Connect OPTO IN 1 signal to the selected trigger operation
NAND 0 Out Connect NAND 0 OUT signal to the selected trigger operation
NAND 1 Out Connect NAND 1 OUT signal to the selected trigger operation
8.3.4 Trigger activation
This command can select how to activate the trigger.
GO-5000M-USB / GO-5000C-USB
Trigger selector
Description
Set to start Acquisition or not
Set to end Acquisition or not
Set to start Frame control or not
Set to start the stream or not
Free-running operation
External trigger operation
- 39 -