6.3
Digital IN/OUT interface
In the GO-5000M-USB and GO-5000C-USB, the digital IN/OUT capability in the software control tool
can assign the necessary signals needed for the system.
6.3.1
Line Selector
In the Line Selector, the following input and output signals can be assigned.
Table – 4
Line selector
Line Selector item
Line 1 Opt 1 Out
Line 2 Opt 2 Out
NAND 0 In 1
NAND 0 In 2
NAND 1 In 1
NAND 1 In 2
Note: Select and connect the line source signal against the item selected in the line selector.
6.3.2
Line Source
Line source signal can be selected from the following table to connect it to the line item
which is selected in the line selector.
Table – 5
Line Source
Line Source item
Low
High
Acquisition Trigger Wait
Acquisition Active
Frame Trigger Wait
Frame Active
Exposure Active
FVAL
PulseGenerator0 Out
Line 5 Opt In
NAND 0 Out
NAND 1 Out
6.3.3
Line Mode
Indicates the status of the interface, input or output.
6.3.4
Line Inverter
Sets the polarity of the selected input or output.
6.3.5
Line Status
Indicates the status of the selected signal, input or output (True=High or False=Low)
GO-5000M-USB / GO-5000C-USB
Description
Opt 1 output from #3 pin of DC In/Trigger 6-Pin on the rear
Opt 2 output from #4 pin of DC In/Trigger 6-Pin on the rear
First input at first NAND gate in GPIO
Second input at first NAND gate in GPIO
First input at second NAND gate in GPIO
Second input at second NAND gate in GPIO
Description
Connect Low Level signal to line item selected in Line Selector, Default setting
Connect High Level signal to line item selected in Line Selector
Connect Acquisition Trigger Wait signal to line item selected in Line Selector
Connect Acquisition Active signal to line item selected in Line Selector
Connect Frame Trigger Wait signal to line item selected in Line Selector
Connect Frame Active signal to line item selected in Line Selector
Connect Exposure Active signal to line item selected in Line Selector
Connect FVAL signal to line item selected in Line Selector
Connect Pulse Generator 0 signal to line item selected in Line Selector
Connect Opt In 1 signal (line 5) to item selected in Line Selector
Connect NAND 0 signal to line item selected in Line Selector
Connect NAND 1 signal to line item selected in Line Selector
- 14 -