Normal Continuous Operation (Timed Exposure Mode/Trigger Mode Off) - JAI SP-5000M-CXP4 User Manual

SP-5000M-CXP4 / SP-5000C-CXP4
7.3.4 Associated GenICam registers
GenICam
Name
Trigger
Selector
Trigger
Mode
Trigger
Software
Trigger
Source
Trigger
Activation
Trigger
Over Lap
7.4.

Normal continuous operation (Timed Exposure Mode/Trigger Mode OFF)

This is used for applications which do not require triggering. In this mode, the video signal for the
auto-iris lens is available if AUX connector is configured with option Type 2.
The frame rate of full pixels readout is 253.8 fps.
Primary settings to use this mode
Trigger Mode: Off
Access Values
Acquisition Start
R/W Acquisition End
Frame Start
On
R/W
Off
W Command
Low
High
Software Trigger
Frame Trigger Wait
Frame Active
Exposure Active
R/W FVAL
PG0 to PG3
User out 0 to 3
TTL 1 in
Opt 1 in
CXP in (Trigger Packet)
Nand 0 to 1
Rising Edge
Falling Edge
R/W
Level High
Level Low
Off
R/W
Read out
Acquisition Control
Acquisition Control
Acquisition Control
Acquisition Control
Acquisition Control
Acquisition Control
- 35 -
Category