Table of Contents
Advertisement
Trigger
CMOS
Exposure
Exposure
Active
FVAL
Note 1: The trigger is input through 6P Optical input. Accordingly, the timing will be changed if
the optical filter is set to the other figures.
Note 2: Other timings are internal operating timing of a camera.
8.8
Video Send Mode
The GO-5000-USB has a Video Send Mode and it includes the following operations.
Table-22 Video send mode
Mode selected
Normal
Multi ROI
Trigger Sequence
Command Sequence
Delayed Readout
8.8.1
Sequence ROI Trigger
This mode allows the user to define a preset sequence of up to 10 images, each with its own ROI,
exposure time and gain values. This mode has two operation modes.
Mode selected
Trigger Sequence
Command Sequence
GO-5000M-USB / GO-5000C-USB
t1
t2
Exposure Period
t1
t2
10 μs (Min)
102µs
Fig.26 RCT mode timing
Index selection method
Normal operation
Up to 5 ROI images can be set up. Each image is output
independently.
Up to 10 indexes can be set for ROI, Exposure Time and Gain.
Select the index by using the Frame Start trigger signal.
Up to 10 indexes can be set for ROI, Exposure time and Gain.
Select the index number to assign directly by using the
Command Sequence Index command.
Up to 7 frames can be stored (8-bit). Each image can be
output by Acquisition Transfer Start trigger timing.
Index selection method
Select the index by using the Frame Start trigger signal. (The
setting index can be determined by the Next Index setting.)
Select the index number to assign directly by using the
Command Sequence Index command.
- 44 -
t3
t3
5L ～6L
Advertisement
Table of Contents
