Test The Installation - Humminbird 360 Imaging Installation Manual

7

| Test the Installation

1. Carefully inspect the area around the Transducer Deployment System for any
obstructions that may interfere with deployment.
2. Turn on the power source from the switch.
3. Standing clear of the Transducer Deployment System, press and hold the
– key to deploy the transducer pod.
4. The transducer pod will begin to deploy. Release the – key when the
transducer pod has been deployed sufficiently to determine it is working.
5. Press and hold the
stowed.
NOTE: If the transducer did not deploy successfully, check the power connections at the
switch and on the Transducer Deployment System. See Section 6. Route the Cables and
Connect Power and Troubleshooting for more information.
•
key. Release the key when the transducer pod is fully
31
— Key
Deploy
•
Key
Retract
Installation - Test