Table of Contents
Advertisement
Introduction
This manual will guide you through the following installation requirements for the
360 Imaging™ Transducer Deployment System:
Installing the GPS Receiver/Heading Sensor
Installing the Transducer Deployment System
Connecting to the Control Head and Power
Testing the Installation
Powering Off
Before proceeding with this installation, the Humminbird® control head
should be installed. See your Humminbird® control head installation guide
for instructions. The 360 Imaging™ Transducer Deployment System can
be connected directly to the control head or to a Humminbird® Ethernet
Switch (optional) for networking. See the Ethernet Switch accessory guide
to install the Ethernet Switch.
NOTE: The installation of this advanced accessory should be performed by a qualified marine
technician.
1
Introduction
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 360 Imaging and is the answer not in the manual?
Questions and answers