Humminbird 360 Imaging Installation Manual page 10

Supplies
In addition to the hardware included with your Transducer Deployment System, you
will need the following supplies:
Drill with various drill bits
Electrical tape
Awl or pencil
1/2" & 7/16" sizes in wrenches, ratchets, and sockets
Torque wrench with 5 - 7 FT/LB capacity
3M Marine Adhesive Sealant 5200 (recommended)
or Marine Grade Adhesive Sealant
Marine-grade silicone caulk or sealant
Cable ties for cable routing
4' straight edge or level
Tape measure
8 A fuse
Safety goggles
Dust mask
Cables: Depending on your Humminbird® model and system configuration, you
may need to purchase additional cables, as shown below. Visit our Web site at
humminbird.com or call our Customer Resource Center at 1-800-633-1468.
• 700 Series™ with Ethernet: To connect the Ethernet to the control head,
you will need to purchase the Ethernet Adapter Cable (AS EC QDE).
• Extention Cables are available for Ethernet and the GPS Receiver/Heading
Sensor.
• Y-Cable: If the COM port on the control head is already used by another
installed accessory, you will need to purchase a Humminbird® Y-Cable to
add the GPS Receiver/Heading Sensor to the installation.
Installation 4