Transducer Maintenance; Transducer Deployment System Maintenance - Humminbird 360 Imaging Installation Manual

Transducer Maintenance

Use the following information to maintain the transducer operation.
• If your boat remains in the water for long periods of time, algae and other
marine growth can reduce the effectiveness of the transducer. Periodically
clean the face of the transducer with a cloth dampened with fresh water.
• If your boat remains out of the water for a long period of time, it may take
some time to wet the transducer when it is returned to the water. Small air
bubbles can climb to the surface of the transducer and interfere with proper
operation. These bubbles dissipate with time, or you can wipe the face of the
transducer with your fingers after the transducer is in the water.

Transducer Deployment System Maintenance

Use the following information to maintain the installation of the Transducer
Deployment System.
• Check the tension of the 4 vertical adjustment nuts after initial use and
periodically thereafter to ensure that the installation remains stable.
• If your boat will be in long-term storage, remove the Transducer Deployment
System from the bracket and store it in –40°F to 158°F (–40°C to 70°C), dry
conditions.
• To keep the Transducer Deployment System clean, wipe the surfaces with a
cloth dampened with fresh water.
• "360 is Due for Maintenance" The 360 Imaging™ Transducer Deployment
System requires routine maintenance after 5000 deployments to ensure
continued problem-free operation and to prevent damage to the unit. A
message will display on the control head screen when 5000 deployments
have been reached.
If you receive this message on your control head, contact our Customer
Resource Center at 1-800-633-1468 to schedule maintenance.
43 Maintenance