Humminbird 360 Imaging Installation Manual page 35

WARNING! The Transducer Deployment System should be connected to a
main switch, fuse panel, or battery switch. Humminbird® does not recommend
connecting to a battery without a fuse and a switch.
NOTE: Humminbird® is not responsible for over-voltage or over-current failures. The
Transducer Deployment System must have adequate protection through the proper
selection and installation of an 8 Amp fuse.
NOTE: A 6' (2 m) long power cable is included to supply power to the Transducer
Deployment System. You may shorten or lengthen the cable using 18 gauge multi-stranded
copper wire.
CAUTION! Some boats have 24 or 36 Volt electric systems, but the Transducer Deployment
System MUST be connected to a 12 VDC power supply.
6. Power: Insert the Power Cable Connector into
the Power port on the Transducer Deployment
System. The connectors are keyed to prevent
reversed installation, so be careful not to force
the connector into the port. Hand-tighten the
screw nut.
7. Route the Power Cable down through the cable
channel on the Transducer Deployment
System, tucking the cable into the channel as
you go.
8. Route the power cable to the main switch or
fuse panel (usually located near the console). If
you must connect to a battery, connect to a
battery switch (not included).
through the Cable Channel
Channel
29
Routing the Cables
Cable
Ports
Cable
Installation - Cables