Humminbird 360 Imaging Installation Manual page 31

4. Place a straight edge along the bottom of the hull and measure the distance
to the bottom of the transducer pod. Confirm that the the pod is 8" (20.3 cm)
above the bottom line of the hull. If you need to make adjustments to the pod
height, consider the following:
• To adjust the height of the Transducer Deployment System, re-install the
hardware in step three on a higher or lower set of holes.
• If you cannot lower the Transducer Deployment System any further
based on the installation location of the transom bracket, you can lower
the height by 3" (7.6 cm) by mounting the transducer bracket upside
down. Uninstall the Transducer Deployment System, and return to the
Install the Transducer Bracket section.
NOTE: Additional adjustments may need to be made after a trial run on the water.
Installation Height, at least 8" (20.3 cm) above the bottom line of the hull
8"
25 Installation - Transducer