8. Compare the pins in the connectors with the illustration Checking the Pins to
confirm they've stayed in place.
If the pins have remained installed, proceed to the next step.
If the pins have been pulled out of the connectors, you will need to send
the full Transducer Deployment System. If this is the case, call our Customer
Resource Center at 1-800-633-1468.
9. Place the pod in a sealed plastic bag to prevent leaking. Pad the package as
needed so the pod is secure and protected during shipment.
Also, save any loose parts that were removed; you will need them to
reconnect the pod.
10. Wrap the connectors on the Transducer Deployment System with plastic
wrap (or a similar material) to protect them from potential environmental
damage (water, dust, etc.).
Removing the Pod (for authorized repair only)
Checking the Pins
Connector 1
All pins must
be populated,
except for this
center pin.
Connector 2
50