Volkswagen Golf Variant 2007 Workshop Manual page 210

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
General body repairs, interior - Edition 12.2009
– Disconnect window regulator switch wiring harness from door
trim.
– Depending on vehicle equipment, disconnect wiring harness‐
es from upper part of grip moulding.
– Remove the two bolts -2- in area of grip moulding (1.5 Nm).
– Remove bolt -3- and the three bolts -4- (2 Nm).
– Release lower part of door trim from mountings using removal
pliers -3392- .
– Release sides of door trim from mountings using removal pli‐
ers -3392- .
– Pull door trim upwards vertically out of window slot seal.
– If vehicle is equipped with a radio system, disconnect wiring
harness from loudspeaker.
– Disconnect wiring harness of door trim from door control unit.
– Detach Bowden cable -5- from interior door handle -6-.
– Remove bolt -7- (2 Nm) and lever triangular mirror cover -8-
out of fasteners using removal wedge -3409- .
– If vehicle is equipped with a radio system, disconnect loud‐
speaker wiring harness from cover.
202
Rep. Gr.70 - Trim, insulation