Rear Panels And Cabling; Power, A/V Input, And Video Output Connections - Extron electronics System 5 IP Series User Manual

Installation: Labeling, Mounting, Cabling, cont'd

Rear Panels and Cabling

Power, A/V input, and video output connections

100-240V 1.3A
R/VID
R/VID
50-60Hz
1
1
2
3
4
5
2-4 System 5 IP Switchers • Installation: Labeling, Mounting, Cabling
G/Y B/C H V
VID
Y C
Y/C
H V
G/Y B/C
2
Power connector — After you have completed the audio/video and control
connections, connect a standard IEC power cord from the AC power supply
to this connector.
Inputs 1 and 2: RGBHV/S-video/composite video inputs — Connect cables
from an RGBHV, S-video (Y/C), or composite video source to each of these
RGBHV
R/VID G/Y B/C H
Y C
S-video
R/VID G/Y B/C H
Inputs 3 and 4: S-video/composite video inputs — Connect the cable from
either an S-video (Y/C) source (using the 4-pin mini DIN connector) or a
composite video (Vid) source (using the BNC connector) to each of these
inputs. Inputs 3 and 4 are not configurable.
Audio inputs — These inputs correspond to the like-numbered video
inputs. For each input, connect the cable from a balanced or unbalanced
stereo or mono audio input source. See the wiring diagrams below.
Tip
Sleeve
Tip
Sleeve
Unbalanced Stereo Input
(high impedance)
Tip
Sleeve
Tip
Sleeve
Unbalanced Mono Input
(high impedance)
After the audio inputs and outputs are connected, see pages 3-5 through 3-7,
and pages 3-9, 4-11, and 5-9 for instructions on how to adjust the per-input
audio levels.
Display outputs — Cable these output BNC connectors to an RGBHV,
R
G
B
Y
H C
V VID
RGBHV Composite S-video
Video
VID
R G
B Y
H C
Y/C V VID
3 5
inputs. See the diagrams below.
Inputs must be configured for either
V
video or RGB. See chapters three,
four, and five for details.
V R/VID
Tip
Ring
Sleeve (s)
Tip
Ring
Balanced Stereo Input
(high impedance)
Tip
Ring
Sleeve (s)
Tip
Ring
Balanced Mono Input
(high impedance)
S-video (Y/C), or composite video
port on the projector or display. See
Y = luma
the diagram at left.
C = chroma
PROJ CONT IR/SERIAL OUT CM/IR/SCP
A B C D
RS-232
B C D E
A
Tx Rx G Ps G +V S G S G S G S G +V G CM IR SCP
L 1 R
L 2 R L 3 R L 4 R
4
Composite Video
G/Y B/C H V
The length of exposed wires is critical.
The ideal length is 0.2" (5 mm).
• If the stripped section of wire is
longer than 0.2", the exposed
wires may touch, causing a
short circuit between them.
• If the stripped section of wire is
shorter than 0.2", wires can be
easily pulled out even if tightly
fastened by the captive screws.
0.2" (5 mm) max.
Do not tin the wires!