REP 10.15 Fuser Heat Roller and Bearings
Parts List on
PL 10.11 Item 12
Removal
This procedure lists steps to remove the Heat Roller and Bearings from the Fuser.
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Do not touch the Fuser while it is hot.
Fuser plastic and metal components are easily over stressed, bent, or broken. Use care when
releasing hooks that secure Fuser covers and guides.
1.
Remove the Rear Door,
REP
28.6.
2.
Remove the Fuser,
REP
10.10.
3.
Remove 3 screws (2 metal) and (1 plastic) that secure the Fuser top cover,
Figure 1 Remove the Fuser top cover
Repairs
REP 10.15
WARNING
WARNING
CAUTION
4.
Remove 3 screws (Black, plastic) that secure the duplex cover to the Fuser,
Figure
1.
5.
Open the lower exit guide,
5/2011
4-106
Figure 2 Remove the duplex cover
Figure
3.
Revision - Xerox Internal Use Only
Phaser 4600/4620 Printer Service Manual
Figure
2.