Xerox Phaser 4620 Service Manual page 71

09-200-00, 09-220-00 Toner Empty RAP
09-200-00 Toner Cartridge has reached end of life.
09-220-00 Toner Cartridge has reached end of life.
BSD-Reference: WD 7
Initial Actions
• Check Toner Cartridge life count.
• Replace the Toner Cartridge.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Check the Toner Cartridge life counter. Life count at end of life.
Y N
Cycle system power. The error message is displayed.
Y N
Reassemble and perform SCP 6
Replace the Toner Cartridge. The error message is displayed.
Y N
Reassemble and perform SCP 6
Replace the Joint Board, REP 9.8.
Replace the Toner Cartridge.
Revision - Xerox Internal Use Only
Phaser 4600/4620 Printer Service Manual
WARNING
Final Actions.
Final Actions.
09-210-00, 09-270-00 Toner (ADC) Sensor Error RAP
09-210-00 ADC Sensor error.
09-270-00 ADC Sensor communications errors or failure.
BSD-Reference: WD 6
Initial Actions
• Cycle system power.
• Check for obstructions, debris, or accumulations of toner blocking the ADC Sensor and
shutter.
• Check Toner Cartridge life count.
• Check Drum Cartridge life count.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Check the ADC Sensor shutter. Shutter motion is unobstructed.
Y N
Clear the obstructions or repair the damage. The error message is displayed.
Y N
Reassemble and perform
Replace the ADC Sensor, REP
Y N
Reassemble and perform
Remove the Right Cover (REP
message is displayed.
Y N
Reassemble and perform
Replace the MCU Board, REP
Replace the ADC Sensor, REP 9.2. The error message is displayed.
Y N
Reassemble and perform SCP 6
Test Drum Cartridge bias voltages. Bias voltage are within specifications.
Y N
Replace the HVPS, REP 1.4.
Replace these components in order until the error is corrected.
1. Toner Cartridge
2. Drum Cartridge, PL 9.10 Item 1
3. MCU Board, PL 3.10 Item 3
5/2011
09-200-00, 09-220-00, 09-210-00, 09-270-00
2-47
WARNING
SCP 6 Final Actions.
9.2. The error message is displayed.
SCP 6 Final Actions.
28.2) and reseat CN15 on the MCU Board. The
SCP 6 Final Actions.
9.8.
Final Actions.
Status Indicator RAPS
error