Xerox Phaser 4620 Service Manual page 61

08-110-00 Feed Motor Failure RAP
08-110-00 The Feed Drive Assembly failed to rotate.
BSD-Reference: WD 3
Initial Actions
• Check all interlocks.
• Check for obstructions blocking motor rotation.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Cycle system power. The error message is displayed.
Y N
Complete.
Select dC330 code 08-920 to test the Feed Drive. The Feed Drive Assembly rotates (on/
off).
Y N
Remove the Right Cover (REP 28.2) and reseat CN12 on the MCU Board, then retest.
The Feed Drive Assembly rotates.
Y N
Manually rotate the feed motor. The motor rotates freely.
Y N
Check for obstructions in the media path. If no obstructions are present, replace
the Feed Drive Assembly,
Replace the Feed Drive Assembly,
Reassemble and perform SCP 6 Final Actions.
Replace these components in order until the error is corrected.
1. MCU Board, PL 3.10 Item 3
2. HVPS, PL 1.10 Item 1
Revision - Xerox Internal Use Only
Phaser 4600/4620 Printer Service Manual
WARNING
REP 4.4.
REP 4.4.
08-200-00 Jam in Tray 2 RAP
08-200-00 Media remains in the Tray 2 Pick-up Assembly.
BSD-Reference: WD 3
Initial Actions
1. Check media condition.
2. Check for obstructions in the media path.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Check the Nudger, Feed and Separator Rollers for excessive wear or contamination. The roll-
ers are undamaged and clean.
Y N
Clean or replace the rollers.
Check for obstructions or debris in the media path. The media path is clear.
Y N
Clear the media path of obstructions or debris.
Select dC330 code 08-100 to test the Take Away Sensor. The sensor signal changes (high/
low).
Y N
Remove the Right Cover (REP
The sensor signal changes.
Y N
Replace the sensor.
Reassemble and perform SCP 6
Select dC330 code 08-820 to test the Feed Clutch. The clutch is engaged (on/off).
Y N
Remove the Right Cover (REP
The clutch is engaged.
Y N
Replace the Feed Clutch,
Reassemble and perform SCP 6
Select dC330 code 08-920 to test the Feed Drive Assembly. The
rotates (on/off).
Y N
Remove the Right Cover (REP
The Feed Drive Assembly rotates.
Y N
Replace the Feed Drive Assembly,
A B
5/2011
2-37
WARNING
7.25) and reseat CN12 on the MCU Board, then retest.
Final Actions.
28.2) and reseat CN12 on the MCU Board, then retest.
REP 4.2.
Final Actions.
Feed Drive
28.2) and reseat CN12 on the MCU Board, then retest.
REP 4.4.
Status Indicator RAPS
08-110-00, 08-200-00
Assembly